Elenco Electronics RCC-7K Guide de dépannage télécharger pdf (Page 17)

-16-

Figure B

Lay resistor flat against the

PC board.

ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARD

Review the soldering and parts identification instructions on p.5 at this time. In all of the following steps the

components must be installed on the top legend side of the PC board. The board is turned over to

solder the component leads.

Figure D

Align the notch on the socket (if any) with

the notch marked on the PC board. Solder

the socket to the PC board. Insert the IC

into the soc

ket with the notch as shown.

Mount with the band pointing as

sho

wn.

Figure C

Notch

Figure A

L1 - 9 Turn Inductor (this part

has been pre-tuned, you do not

need to adjust it).

(see Figure A)

R13 - 1kΩ 5% 1/4W Res.

(brown-black-red-gold)

(see Figure B)

R14 - 1kΩ 5% 1/4W Res.

(brown-black-red-gold)

(see Figure B)

D2 - 3V Zener Diode

(see Figure C)

IC1 - 16-pin IC Socket

IC1 - SCRX2BC IC

(see Figure D)

Band

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

Elenco Electronics RCC-7K Guide de dépannage Page 17