Elenco Electronics rc snap rover Instructions d'exploitation télécharger pdf (Page 11)

-10-

Project #2

OBJECTIVE: To build a remote control vehicle.

Remote Control Rover

Install six (6) “AA” batteries into the bottom of

the Rover body and one 9V•battery into the

remote control unit (batteries not included).

Install the antenna into the remote control

unit by screwing it in. Place the base grid on

the Rover body; you may lock it into position

by turning the hexagonal alignment posts

(shown here), if desired.

Build the circuit shown by placing all the parts with a black 1 next to them

on the clear plastic base grid first. Then, assemble parts marked with a

2, and finally the parts marked with a 3. Be sure to place the U8 (green),

RX1 (red), D4 (black), and W1 (clear) parts with their (+) side oriented as

shown. Connect the colored jumper wires to the rear of the body as

shown (the colors are interchangeable). Set the channel switches on the

remote control unit and R/C Receiver module (RX1) to the same setting

(A, B, or C).

Turn on the slide switch (S1). Turn on the remote control unit, extend the

antenna, and use the levers to drive the Rover around. The buttons on

the remote control activate a horn (W1) or a light (the D4 LED).

ROVER•REAR

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Elenco Electronics rc snap rover Instructions d'exploitation Page 11